Rustler 31

£3,950.00

Walton on the Naze, Essex

Very interesting RUSTLER 31, originally a long keel classic GRP design by Holman & Pye - this boat has been adapted for use as an ocean crossing vessel, intended for use is the Jester Challenge or similar event.

The GRP hull has been strengthened, all through hulls, most windows and apertures glassed over to provide a fully watertight space. Her engine, interior furniture and electronics were removed so essentially she is a "blank canvas".

Built in around 1965. GRP construction with long keel, keel hung rudder, self draining aft cockpit (draining to transom), stripped out below.

BUILDER

Builder: Russell Anstey Yachts (UK)

Designer: Holman & Pye

DIMENSIONS

LOA: 31.42 ft / 9.58 m

LWL: 24.00 ft / 7.32 m

S.A. (reported): 440.00 ft² / 40.88 m²

Beam: 9.00 ft / 2.74 m

Displacement: 12,768.00 lb / 5,791 kg

Max Draft: 5.50 ft / 1.68 m

In this case we are acting as Brokers only. Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed. The particulars are intended only as a guide and they do not constitute a term of any contract. A prospective Buyer is strongly advised to check the particulars and where appropriate at their own expense to employ a qualified Marine Surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability for such engine on our part. Life-saving appliances do not form part of the inventory and it is for the buyer to ensure they are in date and suitable for their purposes.

Walton on the Naze, Essex

Very interesting RUSTLER 31, originally a long keel classic GRP design by Holman & Pye - this boat has been adapted for use as an ocean crossing vessel, intended for use is the Jester Challenge or similar event.

The GRP hull has been strengthened, all through hulls, most windows and apertures glassed over to provide a fully watertight space. Her engine, interior furniture and electronics were removed so essentially she is a "blank canvas".

Built in around 1965. GRP construction with long keel, keel hung rudder, self draining aft cockpit (draining to transom), stripped out below.

BUILDER

Builder: Russell Anstey Yachts (UK)

Designer: Holman & Pye

DIMENSIONS

LOA: 31.42 ft / 9.58 m

LWL: 24.00 ft / 7.32 m

S.A. (reported): 440.00 ft² / 40.88 m²

Beam: 9.00 ft / 2.74 m

Displacement: 12,768.00 lb / 5,791 kg

Max Draft: 5.50 ft / 1.68 m

In this case we are acting as Brokers only. Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed. The particulars are intended only as a guide and they do not constitute a term of any contract. A prospective Buyer is strongly advised to check the particulars and where appropriate at their own expense to employ a qualified Marine Surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability for such engine on our part. Life-saving appliances do not form part of the inventory and it is for the buyer to ensure they are in date and suitable for their purposes.

Mechanical

Electrical

Navigation

Safety

Deck Gear

Halyard winch, grab rails, air vents, deck hatches, bow roller, cleats.

Sails

Note - Aluminium tapered pole intended for use as a keel stepped mast is included together with furling gear.

Domestic

2 single settee berths. Chart table, galley area.

Owners Comments

The Rustler 31 was intended for use in the Jester Challenge. We understand her previous owner had her hull strengthened and stripped, windows and all apertures glass fibre coated and then epoxy painted to provide a very nice finish.